Thursday, September 4, 2008

Limbert Fern Stand, Felicia's table.

Here is the completed Limbert Fern Stand for my friend Felicia. Its all glued up and sanded and ready for the finishing to begin.










But before I start finsihing its time for a little branding, I like to put my logo in a place that doesn't show unless you really look, this one is under the top. My brand is heated up with a propane torch and tested on scrap pieces of oak, once its hot enough I carefully place it and press firmly, there is no second chance here.
My finish process for an authentic Arts and Crafts look isn't simple and it isn't fast, but it looks great compared to original period pieces and it really "pops" the ray flecks in the quartersawn white oak.
Sand piece to 150 grit and clean with tack rag or vacuum.

Wipe a good coat of dye on, for this piece I chose Transtint Medium Brown dye in water, be sure to cover all sides and keep dye from puddling in corners and at base. Leave to dry for at least 24 hours.
Lightly sand to remove raised grain with 220 grit, avoid oversanding especially at corners and edges.
Pad on a 1LB cut of amber shellac or sanding sealer.
Using a 320 grit sanding pad gently rub surface, clean with tack cloth or vacuum.

Apply Brown Mahagony Gel stain being careful to not cover too large of an area because once dry its very hard to wipe off. Once the gel starts to haze rub it off with a clean lint free cloth, I prefer old T-shirts. This gives you a warm rubbed in look. Let dry overnight.
Pad on 2-3 2LB cut coats of amber shellac, I tightly fold a square of T-shirt material, then soak it in the shellac and squeeze out excess, rub it in until it starts to drag then let dry. The coat of shellac should dry in 30 minutes or less. Repeat until you get the build you want.
Again, using 320 grit sanding pad gently rub surface, clean with a tack cloth or vacuum.
Take a few minutes to go over the whole piece with your clean hand, checking the surface for any rough areas or holidays.
Using a clean square of T-shirt rub in a thick coat of Watco Dark Liquid wax. Avoid plain or light colored waxes as these may leave white residue in the pores of the oak. When the wax is dry buff it out with a clean square of T-shirt.
Let the wax sit and "harden" for a few days then its ready to take in the house or in this case, ready to be shipped across country. Hope you enjoy the table Felicia, it should fit right in with your old house.
"True art expressed in its simplest formula is merely use made beautiful" - Charles Limbert

2 comments:

Margaret said...

It looks spectacular, Brad.

Codex said...

OMG it's so beautiful! I can't wait, you are amazing! Pictures will be posted immediately.