Maloof Inspired Rocker, Charles Brock Plans 4

This weekend I got to some of the really fun parts of the Maloof inspired rocker, shaping some of the parts. To start with I refined some of the cuts on the back legs and smoothed the edges on my oscillating spindle sander. I then chocked up a round over bit in my small hand held router and rounded over the edges I could get to on the back legs. I stayed away from the area of the seat, the arm joint and the headrest. Mr. Brock doesn't talk about routing the edges but what I wanted was to ease the edges and leave myself with a guide for shaping the other areas.

Next I screwed the legs in place and using my micro planes rasps I fit the curves in the legs to the seat, careful not to damage the seat, I cut the legs until it was flush with the seat. I also used the New Wave sanding system
to refine the shape.

I laid out the holes for the back spindles in the back of the seat and after removing the legs I drilled the 1/2 inch holes and rounded over the underside and top of the seat. After a little more sanding on the seat I glued the legs in place and screwed the 3 inch screws in place, one of the back screws ended up going right through on of the spindle holes so those with have to be removed after the glue dries and replaced after the spindles are installed.

I started shaping the arms after aligning them and drilling the dowel holes in the arms to attach them to the front legs. I rough cut the shape of one arm on the bandsaw and then started shaping it with the microplanes which are quickly becoming my favorite way to carve things. Now I have to rough cut the mate to match and see if I can carve them both to equal, pleasing, comfortable shapes.

"Of course the game is rigged. Don't let that stop you--if you don't play, you can't win."
- Robert Heinlein