Sunday, July 20, 2008

Stickley Coat Rack, Part 3, the end.


Today I completed the Stickley Coat Rack and took it over to my neighbor so that she could take it to her office. It turned out very nice and it was fun to make.









I installed some nice large antiqued bronze coat hooks, three on each side just like the original.









I used my favorite finishing recipe for arts and crafts furniture.

Sand piece to 150 grit and clean with tack rag or vacuum.
Wipe a good coat of dye on, be sure to cover all sides and keep dye from puddling in corners and at base. Leave to dry for at least 24 hours.
Lightly sand to remove raised grain with 220 grit, avoid oversanding especially at corners and edges.
Pad on a 1LB cut of amber shellac or sanding sealer.
Using a 320 grit sanding pad gently rub surface, clean with tack cloth or vacuum.
Apply Brown Mahogany Gel stain being careful to not cover too large of an area because once dry its very hard to wipe off. Once the gel starts to haze rub it off with a clean lint free cloth, I prefer old T-shirts. This gives you a warm rubbed in look. Let dry overnight.
Pad on 2-3 2LB cut coats of amber shellac, I tightly fold a square of T-shirt material, then soak it in the shellac and squeeze out excess, rub it in until it starts to drag then let dry. The coat of shellac should dry in 30 minutes or less. Repeat until you get the build you want.
Again, using 320 grit sanding pad gently rub surface, clean with a tack cloth or vacuum.
Take a few minutes to go over the whole piece with your clean hand, checking the surface for any rough areas or holidays.
Using a clean square of T-shirt rub in a thick coat of Watco Dark Liquid wax. Avoid plain or light colored waxes as these may leave white residue in the pores of the oak. When the wax is dry buff it out with a clean square of T-shirt.

I posted this in February but I wanted to revisit it because its been a while and people in the Woodwhisperer chat room have been asking me about it recently. As a reward for myself I picked up a L-N low angle block plane when I visited Woodcraft today, I've been wanting one for a while now.

1 comment:

Margaret said...

The stain looks just beautiful!