Sunday, September 5, 2010

The Rest of the Beginning

You may remember the front of this cabinet from my post The Beginning from way back in December in which I created the door with a cherry tree motif using a bolection inlay technique which left the branches and blossoms lightly proud of the surface.

I started the rest of the cabinet by designing it using SketchUp, I continued the wood combination from the door, cherry for the sides, walnut for the shelves and the top/bottom, curly maple for the drawer and the back.
The box is joined with finger joints to highlight the contrasting woods, the shelves are let into the sides with dadoes. The back is 1/4 inch birch plywood with curly maple veneer. The drawer is curly maple with a 1 inch hole for a pull.

I used a 1/2 inch quarter round bit on the inside edge of the hinge side of the door then used a 1/4 inch brass rod attached from the top and the bottom as a pivot hinge. I used a cove bit to route a handle into the free side to keep the lines clean and simple. The door rests inside the edge of the top and bottom letting the walnut frame the door.

The finish is as simple as it comes, a few coats of Watco Danish Oil, Natural, followed by a rubbing with paste wax. I installed a french cleat to the back of the cabinet and attached it to the wall that way. I've very happy with the way this came out. I enjoy making Stickley, Limbert, and Greene & Green reproductions but sometimes it's really nice to design something yourself and see it come to life.



It's a job that's never started that takes the longest to finish.
J. R. R. Tolkien